Weighted pull-ups: when to add load, how much, and how to keep adding it

Start weighted pull-ups once you own 8 to 10 strict reps, ideally with about 12 dips and three months at that level. Begin with 2.5 to 5 kg on a belt or vest, work sets of 3 to 6 reps with a rep or two in reserve, and add the smallest plate when every set hits the top.

General information, not medical advice. Stop if you feel dizzy or unwell, and ask a professional about any health concern.

When you are ready to add weight

The weighted pull-up hangs off the pull-up on our map and leads to one place: one-arm negatives.

What you want before the first plate:

  • Pull-ups: eight to ten clean reps that stay steady from set to set.
  • Dips: about 12, with similar control.
  • Time: about three months at that level, so connective tissue can adapt.

The Calisthenics app opens a skill once the skills before it reach level 2, which for this one means 5 pull-ups. That lets you try a light load early. Our number for real weighted work is higher: 10 strict reps, the top level of the bodyweight pull-up.

Move on when

10 strict bodyweight pull-ups: locked arms at the bottom, chin over the bar, no kip, every rep the same.

How much to start with, and how to add it

First load: 2.5 or 5 kg at most, depending on your level. Start lighter than you think.

When to add: when 3 sets of 5 at the current load feel easy. If 5 reps are easy, wait a week or two before the next increase anyway.

How much to add: steps of 0.5 to 1.25 kg are usually enough; even 2.5 kg can cut your range or break your technique. Small plates, often.

The levels count reps at a stated load. Write the load next to every set, because reps only count at that weight.

Rep ranges: what the evidence supports

A 2021 review by Schoenfeld and colleagues re-examined the old idea that low reps build strength, medium reps build muscle and high reps build endurance. Muscle can be built across a wide spectrum of loads, and heavier loads still suit maximal strength.

Two loading schemes work well for weighted pulling:

  • Double progression in 4 to 6 reps. Keep the load until every set reaches 6 with one or two reps in reserve, add the smallest plate, drop back to 4. Two focused sessions a week.
  • Low reps, 1 to 5. When you complete 3 sets of 5, add a little load. Rest 2 to 5 minutes.

Our dose: between 3 and 5 sets, each of 3 to 5 reps, with 2 to 3 minutes between them, on two days a week. End every set with a rep or two still in the tank.

How to do a weighted pull-up

Overhand grip, shoulder width or slightly wider, load hanging from a belt or carried in a vest.

  1. Attach the load and hang with straight arms.
  2. Set the shoulders down and brace.
  3. Drive the elbows down and back.
  4. Pull until the chin is above the bar.
  5. Lower over 3 to 4 seconds to straight arms.

Cues: drive through the elbows, body straight with no swing, chin above the bar, slow way down.

Mistakes: cutting the range short at either end; swinging the load (start each rep from a still hang); grinding ugly reps (end the set when you start kicking or shortening).

Extra drills: a weighted top hold of 3 x 5 seconds, weighted negatives slightly heavier than your working load lowered over 4 seconds for 3 x 2, then 2 x 8 bodyweight pull-ups as back-off volume.

Belt or vest

Belt: a dip belt with a chain and plates is the most common setup. It hangs the load from the hips, so it keeps working as the numbers climb.

Vest or backpack: fine for low to moderate loads at the start, but both limit later progress. Early on, a backpack with water bottles or books works.

The number for one-arm work

If you are loading pull-ups to chase the one-arm pull-up, this is the number to build toward.

Body weightOne third added (start one-arm negatives)One half added (first full rep, for most)
60 kg20 kg30 kg
70 kg23 kg35 kg
80 kg27 kg40 kg
90 kg30 kg45 kg

All for 3 to 5 clean reps. Lighter lifters often need a little less, because a one-arm rep is easier at low body weight.

Our number: about one third of your body weight added for 3 to 5 clean reps before you start one-arm negatives, then keep building toward a half while you train them. On our map, one-arm negatives need two gates: this one and the archer pull-up. The archer adds the one-sided top range that a two-arm pull does not train.

Load your elbows gradually

Added load raises the stress on elbows and shoulders. Increase it in small steps and control the bottom of every rep instead of dropping into the hang. If you are coming from bodyweight work, keep chin-ups and pull-ups both in the week so the load spreads across two grips.

Questions people ask

How many pull-ups before adding weight?

8 to 10 clean reps, ideally with about 12 dips and three months at that level. We use 10 strict reps, the top level of the bodyweight pull-up. Clean means straight arms at the bottom, chin over the bar, no kick.

How much weight should I start with on weighted pull-ups?

2.5 or 5 kg at most, depending on your level. Add load only when 3 sets of 5 feel solid, in steps of 0.5 to 1.25 kg: 2.5 kg jumps can shorten your range.

How much weight do I need for a one-arm pull-up?

About a third of your body weight added for 3 to 5 clean reps before one-arm negatives, and close to a half by the time the first full one-arm rep arrives. For a 75 kg lifter that is about 25 kg, then about 35 kg.

Belt or vest for weighted pull-ups?

A dip belt with a chain and plates is the most common choice and keeps going as the load climbs. A vest or a loaded backpack works for small loads early on, but both limit how far you can progress later.

Sources

Made by EASYTECH, who also make Calisthenics.